Frequently Asked Questions
Frequently Asked Questions
Number of objects shown in the view in single page
Posted by Mikko Punta (M-Files) on 21 March 2019 01:36 PM
By default, 500 objects are shown in the single page.
This can be changed with the following client-side registry key:
Key: HKEY_CURRENT_USER\SOFTWARE\Motive\M-Files\[Version]\Client\MFShell\[VaultName]\
Value name: ObjectsPerGroupInViews
Value type: REG_DWORD (DWORD 32-bit Value)
Value data: default 500
In the key, replace <version> with the M-Files version you are using and the <Vault name> with the name of the correct vault. For example, when using version 19.2.7378.4 and the used vault is named "Project Vault", the registry key would be HKEY_CURRENT_USER\SOFTWARE\Motive\M-Files\19.2.7378.4\Client\MFShell\Project Vault\
After setting the registry value, the client display settings need to be 'Reset to Common Defaults' (View -> 'Reset Display Settings to Defaults').
(1 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako case